Enabling the SIR System
Courtesy of GENERAL MOTORS COMPANY
- Remove the key from the ignition.
- Connect the RF side impact module yellow 2-way connector (1) located under the passenger seat.
- Install the connector position assurance (CPA) to the RF side impact module yellow 2-way connector (2) located under the passenger seat.
- Connect the LF side impact module yellow 2-way connector (1) located under the driver seat.
- Install the CPA to the LF side impact module yellow 2-way connector (2) located under the driver seat.
Courtesy of GENERAL MOTORS COMPANY
- Connect the IP module yellow 2-way connector (1) located behind the main IP support.
- Install the CPA to the IP module yellow 2-way connector (1) located behind the main IP support.
Courtesy of GENERAL MOTORS COMPANY
- Connect the steering wheel module yellow 2-way connector (2) located at the base of the steering column.
- Install the CPA (1) to the steering wheel module yellow 2-way connector (2) located at the base of the steering column.
- Install the AIR BAG Fuse to the fuse block.
- Staying well away from all air bags, turn ON the ignition, with the engine OFF.
- The AIR BAG indicator will flash 7 times.
- The AIR BAG indicator will then turn OFF.
- Perform the Diagnostic System Check - SIR if the AIR BAG indicator does not operate as described.