LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2001 >> C3500 HD 8.1 G, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel And Steering Column - Tilt >> Repair Instructions >> Electronic Column Lock Module - Assemble - Off Vehicle >> Installation Procedure

Installation Procedure

    Fig 1: View Of Lock Cylinder Housing TORX Screws
    GM1413838Courtesy of GENERAL MOTORS COMPANY
  1. Refer to Fastener Notice in Cautions and Notices.

    Install 3 TORX® screws into the lock cylinder housing.

    Tighten 

    Tighten the TORX® screws to 7Y(62 lb in).

  2. Install the turn signal cancel cam. Refer to Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle (Floor Shift) , Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle (Column Shift) .
  3. Install the park lock cable into the lock cylinder housing.
  4. Install the ignition switch. Refer to Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle .
  5. Enable the SIR system. Refer to Enabling the SIR System in SIR.
scientia non olet · About LEMON Manuals