LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1996 >> C3500 HD 7.4 J, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Engine Mechanical - 5.0L V8 - VIN [M]) >> Overhaul >> Cylinder Block Assembly >> Thrust Bearing

Thrust Bearing

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1997 GMC Savana, 1997 GMC Pickup, 1997 Chevrolet Pickup, 1997 Chevrolet Chevy Van, and 1997 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install main bearing caps (except rear), and tighten cap bolts to specification. See TORQUE SPECIFICATIONS  table. Install rear main bearing cap and tighten cap bolts to 10 ft. lbs. (14 N.m).
  2. Tap crankshaft rearward then forward to align thrust surfaces. Tighten rear main bearing cap bolts to specification. Measure crankshaft end play at forward thrust surface of rear main bearing cap. See CRANKSHAFT, MAIN & CONNECTING ROD BEARINGS  table under ENGINE SPECIFICATIONS.
scientia non olet · About LEMON Manuals