LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1996 >> C3500 HD 7.4 J, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Engine Mechanical - 5.0L V8 - VIN [M]) >> Engine Oiling >> Oil Pump >> Reassembly & Installation

Reassembly & Installation

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1997 GMC Savana, 1997 GMC Pickup, 1997 Chevrolet Pickup, 1997 Chevrolet Chevy Van, and 1997 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install pump gears into pump body with marked gear teeth indexed. If pick-up tube was removed, apply sealant to tube end. Tap tube end into pump using plastic hammer. Reassemble remaining components in reverse order of disassembly.
  2. Prime oil pump with engine oil. Install pump and extension shaft, ensuring slot on top of extension shaft engages with drive tang on end of distributor shaft. Tighten oil pump bolt to specification. See TORQUE SPECIFICATIONS  table. Install oil pan.
scientia non olet · About LEMON Manuals