Removal & Installation: Engine: Installation

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, and 1995 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.

To install, reverse removal procedure. DO NOT tighten engine mount bolts until all bolts are installed. If vertical bolts on right or left engine mount were loosened, axle shaft length must be checked.
To determine axle shaft length, measure distance between inner edge of outboard boot and inner edge of inboard boot at 6 o'clock position. See Fig 1.

Fig 1: Measuring Axle Shaft Length
Courtesy of CHRYSLER CORP.

Axle shaft length must be within specification. Refer to AXLE SHAFT LENGTH SPECIFICATIONS table.

AXLE SHAFT LENGTH SPECIFICATIONS

Application		In. (mm)
AWD Models
Right Axle Shaft		11.5-11.9 (292-302)
Left Axle Shaft		7.2-7.6 (183-193)
2WD Models
Right Axle Shaft		18.7-19.1 (475-485)
Left Axle Shaft		7.2-7.6 (183-193)

Adjust axle shaft length to specification by sliding engine in slots on engine mounts. Tighten all engine mount bolts once correct axle shaft length is obtained.
CAUTION: Tighten vertical bolt in right engine mount bracket before tightening through-bolt.
Ensure the reference mark is aligned on torque converter and flexplate. Tighten all bolts/nuts to specification. Refer to TORQUE SPECIFICATIONS .
Use proper procedure when installing fuel lines. Refer to FUEL LINES & FITTINGS .
Fill and bleed cooling system. See COOLING SYSTEM BLEEDING .