LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (3.3L V6 CNG - VIN [J]) >> Removal & Installation >> Cooling System Bleeding

Cooling System Bleeding

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, and 1995 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.
  1. To bleed cooling system, remove engine temperature sending unit. Engine temperature sending unit is located in front of cylinder head, near thermostat housing, just below spark plug wire holder.
  2. Fill cooling system until coolant reaches engine temperature sending unit level. Install and tighten engine temperature sending unit to 60 INCH lbs. (6.8 N.m). Finish filling cooling system.
scientia non olet · About LEMON Manuals