LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (3.3L V6 CNG - VIN [J]) >> Removal & Installation >> Cylinder Head >> Installation

Cylinder Head: Installation

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, and 1995 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse removal procedure. Ensure cylinder head gasket is installed with identification number facing away from cylinder block.
  2. Install and tighten cylinder head bolts to specification in sequence using 4 steps. Refer to TORQUE SPECIFICATIONS . Refer to Fig. Figure.
    CAUTION: No. 9 cylinder head bolt must be tightened to specification after all other bolts are tightened in sequence to specification.
  3. When tightening cylinder head bolts that required additional 1/4 turn, torque should exceed 90 ft. lbs. (122 N.m). Replace cylinder head bolt if torque does not exceed specification.
  4. To install remaining components, reverse removal procedure. Ensure proper procedure is followed when installing rocker arm assembly and push rods. See ROCKER ARMS & PUSH RODS .
  5. Fill and bleed cooling system. See COOLING SYSTEM BLEEDING .
scientia non olet · About LEMON Manuals