Removal & Installation: Engine: Installation
WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Dodge Dakota, and 1995 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse removal procedure. DO NOT tighten engine mount bolts until all bolts are installed. If vertical bolts on right or left upper mount on frame rail were loosened, axle shaft length must be checked.
- To determine axle shaft length, measure distance between inner edge of outboard boot and inner edge of inboard boot at 6 o'clock position. See Fig 1.
- Slide engine in slots on engine mounts so axle shaft length is within specification. See AXLE SHAFT LENGTH SPECIFICATIONS table. Tighten all mounting bolts to specification once correct axle length is obtained. See TORQUE SPECIFICATIONS .NOTE: Tighten vertical bolt in right mount bracket before tightening long through-bolt.
- Ensure reference mark is aligned on torque converter and flexplate. Fill and bleed cooling system. See COOLING SYSTEM BLEEDING under REMOVAL & INSTALLATION.
AXLE SHAFT LENGTH SPECIFICATIONS
| Application | In. (mm) |
|---|---|
| Right Axle Shaft | 20.5-20.9 (521-531) |
| Left Axle Shaft | 9.0-9.4 (229-239) |