Test TC-29A - Injector #2 Control CKT (Injectors No. 4 & 9) (DTC 27)
WARNING: This page is about a different car, the 1995 Dodge Pickup and 1995 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION
. For wiring diagrams, see WIRING DIAGRAMS
section at the end of this article.
- Turn ignition off. Disconnect Powertrain Control Module (PCM) connector. Using an external ohmmeter, check resistance between PCM terminals No. 15, injector No. 2 driver circuit (Tan wire) and No. 57, ASD relay output circuit (Dark Green/Orange wire). If resistance is 6-18 ohms, replace PCM. Perform TEST VER-2.
- If resistance is not 6-18 ohms, check resistance of PCM terminal No. 15, injectors No. 4 and 9 driver circuit (Tan wire) using scan tool in ohmmeter mode. If resistance is more than 5 ohms, repair open Tan wire. Perform TEST VER-2.
- If resistance is less than 5 ohms, disconnect injector No. 4 connector. Check resistance of PCM terminal No. 15, injectors No. 4 and 9 driver circuit (Tan wire). If resistance is more than 5 ohms, replace injector No. 4. Perform TEST VER-2.
- If resistance is less than 5 ohms, disconnect injector No. 9 connector. Check resistance of PCM terminal No. 15, injectors No. 4 and 9 driver circuit (Tan wire). If resistance is more than 5 ohms, replace injector No. 9. Perform TEST VER-2. If resistance is less than 5 ohms, repair short to ground in Tan wire. Perform TEST VER-2.