LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Engine Controls - Tests W/Codes - 8.0L) >> No-Start Tests >> Test NS-6B - Correcting No Response Condition

Test NS-6B - Correcting No Response Condition

WARNING: This page is about a different car, the 1995 Dodge Pickup and 1995 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION  . For wiring diagrams, see WIRING DIAGRAMS  section at the end of this article.
  1. If ignition is not on when NO RESPONSE message is displayed, turn ignition on to get a response. Test is complete. If ignition is on when NO RESPONSE message is displayed, turn ignition off. Go to next step.
  2. Disconnect scan tool from Data Link Connector (DLC). Disconnect Powertrain Control Module (PCM) connector. Using an external ohmmeter, check resistance between DLC, Serial Communications Interface (SCI) transmit circuit (Pink wire) and ground. If resistance is less than 5 ohms, repair short to ground in Pink wire. Perform TEST VER-1.
  3. If resistance is more than 5 ohms, use an external ohmmeter to check resistance between DLC, SCI receive circuit (Light Green wire) and ground. If resistance is less than 5 ohms, repair short to ground in Light Green wire. Perform TEST VER-1.
  4. If resistance is more than 5 ohms, using an external ohmmeter, check resistance of SCI transmit circuit (Pink wire) between DLC and PCM connector terminal No. 25. If resistance is more than 5 ohms, repair open Pink wire. Perform TEST VER-1.
  5. If resistance is less than 5 ohms, use an external ohmmeter to check resistance of SCI receive circuit (Light Green wire) between DLC and PCM connector terminal No. 45. If resistance is more than 5 ohms, repair open Light Green wire. Perform TEST VER-1.
  6. If resistance is less than 5 ohms, connect scan tool to a functional DLC on another vehicle. Turn ignition on. Using scan tool, attempt to read trouble codes. If scan tool does not display NO RESPONSE, replace PCM on initial vehicle. Perform TEST VER-1.
  7. If scan tool displays NO RESPONSE, substitute another scan tool adapter cable. Using scan tool, attempt to read trouble codes. If scan tool does not display NO RESPONSE, replace scan tool adapter cable. If scan tool displays NO RESPONSE, repair or replace scan tool.
scientia non olet · About LEMON Manuals