Test TC-1A - Checking For DTCS

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, and 1995 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagrams, see WIRING DIAGRAMS section at the end of this article.

Battery must be fully charged before proceeding. Attempt to start engine. If engine will not start, crank engine for at least 10 seconds. Connect scan tool to Data Link Connector (DLC). Record scan tool Diagnostic Trouble Codes (DTCs).
If scan tool has a blank screen or displays RAM TEST FAILURE, CARTRIDGE ERROR, KEY PAD TEST FAILURE, LOW BATTERY or HIGH BATTERY, scan tool failure is indicated. To diagnose and correct, see VEHICLE COMMUNICATIONS CHRYSLER CORP. BODY CONTROL COMPUTER article in ENGINE PERFORMANCE section.
If scan tool displays NO RESPONSE, go to TEST NS-6A. If DTCs are displayed, see SCAN TOOL DTCS table and perform appropriate test(s). If no DTCs are displayed and a driveability problem is present, go to TEST NTC-1A. If no DTCs are displayed and a no-start problem is present, go to TEST NS-1A.

SCAN TOOL DTCS

DTC

Scan Tool Message

Test No.

Code 11

NO CRANK REFERENCE SIGNAL AT PCM

TC-2A

Code 54

NO CAM SYNC SIGNAL AT PCM

TC-3A

Code 13

NO CHANGE IN MAP FROM START TO RUN

TC-4A

Code 14

MAP SENSOR VOLTAGE TOO LOW

TC-5A

Code 14

MAP SENSOR VOLTAGE TOO HIGH

TC-6A

Code 15

NO VEHICLE SPEED SENSOR SIGNAL

TC-7A

Code 21

O2S SHORTED TO VOLTAGE

TC-8A

Code 21

O2S STAYS AT CENTER

TC-9A

Code 52

O2S STAYS ABOVE CENTER (RICH)

TC-10A

Code 51

O2S STAYS BELOW CENTER (LEAN)

TC-11A

Code 22

ECT SENSOR VOLTAGE TOO HIGH

TC-12A

Code 22

ECT SENSOR VOLTAGE TOO LOW

TC-13A

Code 24

THROTTLE POSITION SENSOR VOLTAGE HIGH

TC-14A

Code 24

THROTTLE POSITION SENSOR VOLTAGE LOW

TC-15A

Code 25

IDLE AIR CONTROL MOTOR CIRCUITS

TC-16A

Code 27

INJECTOR CONTROL CIRCUITS

TC-17A

Code 27

INJECTOR #1 CONTROL CIRCUIT

TC-17B

Code 27

INJECTOR #2 CONTROL CIRCUIT

TC-18A

Code 27

INJECTOR #3 CONTROL CIRCUIT

TC-19A

Code 27

INJECTOR #4 CONTROL CIRCUIT

TC-20A

Code 27

INJECTOR #5 CONTROL CIRCUIT

TC-21A

Code 27

INJECTOR #6 CONTROL CIRCUIT

TC-22A

Code 31

EVAP SOLENOID CIRCUIT

TC-23A

Code 32

EGR SOLENOID CIRCUIT

TC-24A

Code 32

EGR SYSTEM FAILURE

TC-25A

Code 33

A/C CLUTCH RELAY CIRCUIT

TC-26A

Code 35

LOW SPEED FAN CONTROL RELAY CIRCUIT

TC-28A

Code 35

HIGH SPEED FAN CONTROL RELAY CIRCUIT

TC-29A

Code 42

AUTO SHUTDOWN RELAY CONTROL CIRCUIT

TC-30A

Code 42

NO ASD RELAY VOLT SENSE AT PCM

TC-31A

Code 43

IGNITION COIL PRIMARY CIRCUITS

TC-32A

Code 43

IGNITION COIL #1 PRIMARY CIRCUIT

TC-32B

Code 43

IGNITION COIL #2 PRIMARY CIRCUIT

TC-33A

Code 43

IGNITION COIL #3 PRIMARY CIRCUIT

TC-34A

Code 62

PCM FAILURE SRI MILE NOT STORED

TC-35A

Code 63

PCM FAILURE EEPROM WRITE DENIED

TC-35A

Code 53

PCM FAILURE SPI COMMUNICATIONS

⁽¹⁾

Code 44

BATTERY TEMP SENSOR VOLTS OUT OF LIMIT

⁽²⁾

Code 47

CHARGING SYSTEM VOLTAGE TOO LOW

⁽²⁾

Code 46

CHARGING SYSTEM VOLTAGE TOO HIGH

⁽²⁾

Code 41

GENERATOR FIELD NOT SWITCHING PROPERLY

⁽²⁾

Code 17

ENGINE IS COLD TOO LONG

⁽³⁾

Code 53

INTERNAL PCM FAILURE

⁽¹⁾

Code 34

SPEED CONTROL SOLENOID CIRCUITS

⁽⁴⁾

⁽¹⁾	Replace PCM and perform TEST VER-2.

⁽²⁾	See CHRYSLER CORP. - GENERATORS & REGULATORS article in the ELECTRICAL section.

⁽³⁾	Check cooling system if engine temperature does not reach 176°F (80°C) after driving 20 minutes. This code may set in error during very cold slow speed driving.

⁽⁴⁾	See CHRYSLER CORP. CRUISE CONTROL SYSTEMS article in ACCESSORIES EQUIPMENT section.