LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Drive Axle - Gm 10 1/2" >> Removal & Installation >> Wheel Bearings >> Removal

Wheel Bearings: Removal

  1. Remove axle shaft. See AXLE SHAFT . Remove hub/drum assembly. See HUB & DRUM ASSEMBLY . Use a long drift or punch to drive inner bearing, cup, and oil seal from hub. Remove outer bearing retaining ring.
    NOTE: Remove Inner bearing cup and outer bearing retaining ring before removing outer bearing cup.
  2. Use Driver Handle (J-8092) and Outer Bearing Cup Remover/Installer (J-24426) to drive outer bearing and cup out of hub. See Figure.
scientia non olet · About LEMON Manuals