Pinpoint Test F: P060A:44, P060A:47
WARNING: This page is about a different car, the 2022 Ford Police Interceptor Utility and 2022 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
Refer to Electric Powertrain Control - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition SOBDMC P060A:44 Internal Control Module Monitoring Processor Performance: Data Memory Failure This DTC sets when an internal error occurs. SOBDMC P060A:47 Internal Control Module Monitoring Processor Performance: Watchdog/Safety μC Failure This DTC sets when an internal error occurs. Possible Sources
- Inverter System Controller (ISC) calibration
- Inverter System Controller (ISC)
- F1 CHECK FOR INVERTER SYSTEM CONTROLLER (ISC) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, perform the Inverter System Controller (ISC) self-test.
Are any Inverter System Controller (ISC) DTCs other than P060A:44 or P060A:47 present?
Yes DIAGNOSE all other Inverter System Controller (ISC) DTCs, Refer to the Diagnostic Trouble Code (DTC) Chart No For DTC P060A:44 or P060A:47 only GO to F2 - F2 VERIFY THE INVERTER SYSTEM CONTROLLER (ISC) CALIBRATION LEVEL
- Verify the Inverter System Controller (ISC) is at the latest calibration level.
Is the Inverter System Controller (ISC) at the latest calibration level?
Yes GO to F3 No UPDATE the Inverter System Controller (ISC) to the latest calibration level. - F3 CLEAR AND CHECK THE INVERTER SYSTEM CONTROLLER (ISC) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, clear the Inverter System Controller (ISC) DTCs.
- Using a diagnostic scan tool, perform the Inverter System Controller (ISC) self-test.
Are DTCs P060A:44 or P060A:47 present in the Inverter System Controller (ISC)?
Yes CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new Inverter System Controller (ISC). Refer to Inverter System Controller [SOBDMC] . No The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.