Diagnostic Trouble Code (DTC) Chart
WARNING: This page is about a different car, the 2022 Ford Bronco Sport. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| Module | DTC | Description | Action |
|---|---|---|---|
| APIM | C1001:01 | Vision System Camera: General Electrical Failure | GO to Pinpoint Test A |
| APIM | C1001:01 | Vision System Camera: General Electrical Failure | GO to Pinpoint Test J |
| BCM | B115E:01 | Camera Module: General Electrical Failure | GO to Pinpoint Test A |
| BCM | B115E:02 | Camera Module: General Signal Failure | GO to Pinpoint Test A |
| BCM | B115E:08 | Camera Module: Bus Signal/Message Failures | GO to Pinpoint Test A |
| BCM | B115E:49 | Camera Module: Internal Electronic Failure | GO to Pinpoint Test A |
| BCM | B115E:55 | Camera Module: Not Configured | GO to Pinpoint Test G |
| BCM | B115E:9A | Camera Module: Component or System Operating Conditions | GO to Pinpoint Test A |
| IPMB | B115E:08 | Camera Module: Bus Signal/Message Failures | GO to Pinpoint Test L |
| IPMB | B115E:49 | Camera Module: Internal Electronic Failure | GO to Pinpoint Test Q |
| IPMB | B115E:55 | Camera Module: Not Configured | GO to Pinpoint Test S |
| IPMB | B148E:08 | Front Camera: Bus Signal/Message Failures | GO to Pinpoint Test M |
| IPMB | B148E:49 | Front Camera: Internal Electronic Failure | GO to Pinpoint Test R |
| IPMB | B148E:55 | Front Camera: Not Configured | GO to Pinpoint Test S |
| IPMB | U0121:87 | Lost Communication With Anti-Lock Brake System (ABS) Control Module "A": Missing Message | GO to Pinpoint Test U |
| IPMB | U0131:00 | Lost Communication With Power Steering Control Module "A": No Sub Type Information | GO to Pinpoint Test V |
| IPMB | U0420:86 | Invalid Data Received from Power Steering Control Module "A": Signal Invalid | GO to Pinpoint Test V |
| IPMB | U201A:55 | Control Module Main Calibration Data: Not Configured | GO to Pinpoint Test W |
| IPMB | U2100:00 | Initial Configuration Not Complete: No Sub Type Information | GO to Pinpoint Test W |
| IPMB | U3000:42 | Control Module: General Memory Failure | GO to Pinpoint Test X |