Pinpoint Test F : The CHMSL Camera Is Inoperative: Notes
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
Refer to Parking Aid for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Parking Aid - System Operation and Component Description .
IPMB DTC Fault Trigger Conditions - 2 Camera System
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B148E:08 | Front Camera: Bus Signal/Message Failure | A continuous and on-demand DTC that sets in the IPMB when there is a LIN communication fault from the CHMSL camera. |
IPMB DTC Fault Trigger Conditions - 3 Or More Camera System
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B152E:08 | Rear Camera 2: Bus Signal/Message Failure | A continuous and on-demand DTC that sets in the IPMB when there is a LIN communication fault from the CHMSL camera. |
Possible Causes
- Fuse
- Wiring, terminals or connectors
- Communication network concern
- Camera
- TR input concern
- LIN concern
- IPMB
Visual Inspection and Diagnostic Pre-Checks
- BJB fuse 34 (10A).
- Verify the tailgate is fully closed.
- If the CHMSL camera is not configured after replacement, some video functions will be inoperative. Verify the CHMSL camera configuration using the diagnostic scan tool.
NOTE:
Before disconnecting the parking aid camera, verify that the connector is properly seated and latched.