Pinpoint Test E : The Rear Parking Aid Camera Is Inoperative - Vehicles With CHMSL Or Trailer Camera (2 Camera System): Notes
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
Refer to Parking Aid for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Parking Aid - System Operation and Component Description .
IPMB DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B115E:08 | Camera Module: Bus Signal/Message Failure | A continuous and on-demand DTC that sets in the IPMB when there is a LIN communication fault from the rear parking aid camera. |
Possible Causes
- Fuse
- Wiring, terminals or connectors
- Communication network concern
- Camera
- TR input concern
- LIN concern
- IPMB
Visual Inspection and Diagnostic Pre-Checks
- BJB fuse 34 (10A).
- Verify the tailgate is fully closed.
- If the rear parking aid camera is not configured after replacement, some video functions will be inoperative. Verify the rear parking aid camera configuration using the diagnostic scan tool.
NOTE:
Before disconnecting the parking aid camera, verify that the connector is properly seated and latched.