Pinpoint Test C: The Right Heated Rear Seat Is Inoperative
- Refer to CLIMATE CONTROLLED SEATS
for schematic and connector information.
Normal Operation and Fault Conditions
When the RH heated rear seat control switch is activated with the ignition ON, a ground signal is supplied to the heated seat module from the switch. When commanded ON, voltage is supplied to the heated seat switch from the heated seat module to illuminate the switch indicator. The heated seat module also supplies voltage to the RH rear seat cushion and backrest heater mats, which are connected in series. Temperature is maintained by the heated seat module using a sensor contained within the cushion heater mat. The heated seat module supplies a reference voltage to the temperature sensor and monitors the return signal from the temperature sensor for controlling current flow to the heater mats. The heated seat module remains ON, heating the seat and maintaining temperature until switched OFF or the ignition voltage is switched OFF.
REFER to: Rear Seats - System Operation and Component Description .
Possible Sources
- Wiring, terminals or connectors
- Heater mat
- Heated rear seat switch
- Heated rear seat module
- C1 CHECK THE HEATED SEAT SWITCH INPUT
- Ignition OFF.
- Disconnect Heated Rear Seat Module C3304A.
- While pressing and releasing the right heated rear seat switch, measure:
Positive Lead Measurement / Action Negative Lead C3304A-8 Ground
Is the resistance less than 3 ohms when the switch is pressed and greater than 10, 000 ohms when released?
Yes GO to C3 No GO to C2 - C2 CHECK THE HEATED SEAT SWITCH CIRCUIT FOR AN OPEN OR SHORT TO GROUND
- Disconnect Rear Seat Heated Seat Switch C3182.
Are the resistances less than 3 ohms between C3182-3 and C3304A-8, and greater than 10, 000 ohms between C3182-3 and ground?
Yes INSTALL a new heated rear seat switch. REFER to: Heated Rear Seat Switch - SuperCrew . No REPAIR the circuit. - C3 CHECK FOR VOLTAGE TO THE HEATED SEAT MODULE
- Disconnect Heated Rear Seat Module C3304B.
- Measure:
Positive Lead Measurement / Action Negative Lead C3304B-3 Ground
Is the voltage greater than 11 volts?
Yes GO to C4 No REPAIR the circuit. - C4 CHECK THE HEATER CIRCUITS AND HEATER MATS FOR AN OPEN
- Measure:
Positive Lead Measurement / Action Negative Lead C3304B-6 Ground
Is the resistance between 2.5 and 4.5 ohms?
Yes GO to C9 No GO to C5 - Measure:
- C5 CHECK THE HEATER MAT GROUND CIRCUIT FOR AN OPEN
- Disconnect Right Rear Backrest Heater Mat C3170.
- Measure:
Positive Lead Measurement / Action Negative Lead C3170-2 Ground
Is the resistance less than 3 ohms?
Yes GO to C6 No REPAIR the circuit. - C6 CHECK THE HEATER CIRCUIT FOR AN OPEN OR SHORT TO GROUND
- Disconnect Right Rear Cushion Heater Mat C3169.
- Measure:
Positive Lead Measurement / Action Negative Lead C3304B-6 Ground
Are the resistances less than 3 ohms between C3304B-6 and C3169-1, and greater than 10, 000 ohms between C3304B-6 and ground?
Yes GO to C7 No REPAIR the circuit. - C7 CHECK THE CUSHION HEATER MAT FOR AN OPEN
- Measure the component side resistance
between:
Positive Lead Measurement / Action Negative Lead
C3169-1, Component Side
C3169-4, Component Side
Is the resistance between 1.5 and 2.5 ohms?
Yes GO to C8 No INSTALL a new cushion heater mat. REFER to: Seat Heater Mat Removal . - Measure the component side resistance
between:
- C8 CHECK FOR AN OPEN OR A SHORT TO GROUND BETWEEN THE HEATER MATS
- Measure:
Positive Lead Measurement / Action Negative Lead C3169-4 Ground
Are the resistances less than 3 ohms between C3169-4 and C3170-1, and greater than 10, 000 ohms between C3169-4 and ground?
Yes INSTALL a new backrest heater mat. REFER to: Seat Heater Mat Removal . No REPAIR the circuit. - Measure:
- C9 CHECK THE TEMPERATURE SENSOR CIRCUIT FOR A SHORT TO VOLTAGE
- Ignition ON.
- Measure:
Positive Lead Measurement / Action Negative Lead C3304A-9 Ground
Is any voltage present?
Yes REPAIR the circuit. No GO to C10 - C10 CHECK THE TEMPERATURE SENSOR CIRCUIT FOR A SHORT TO GROUND
- Ignition OFF.
- Measure:
Positive Lead Measurement / Action Negative Lead C3304A-9 Ground
Is the resistance greater than 10, 000 ohms?
Yes GO to C11 No REPAIR the circuit. - C11 CHECK THE TEMPERATURE SENSOR AND CIRCUITS FOR AN OPEN
Is the resistance between 300 and 300K ohms?
Yes INSTALL a new heated rear seat module. REFER to: Heated Rear Seat Module - SuperCrew . No GO to C12 - C12 CHECK THE TEMPERATURE SENSOR FOR AN OPEN WITH THE HEATER MAT DISCONNECTED
- Disconnect Right Rear Cushion Heater Mat C3169.
Are the resistances less than 3 ohms?
Yes INSTALL a new backrest heater mat. REFER to: Seat Heater Mat Removal . No REPAIR the circuit in question.