Selector Shaft Seal: Installation
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Slide the selector shaft seal onto the manual shaft.
- Using the special tool, install the selector shaft seal. Use Special Service Tool: 307-549 Installer, Shift Shaft Fluid Seal.
- Install the park manual release lever and nut.
Torque: 177 lb.in (20 Nm)
- Connect the transmission park manual release cable to the transmission lever.
- Pull back on the cable to verify it is installed correctly to the manual lever.
- If equipped, install the splash shield and the retainers.
Torque: 71 lb.in (8 Nm)