Output Shaft Seal: Installation
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Position a new output shaft seal on the special tools. Use Special Service Tool: 205-1018 Installation Tube., 307-782 Installer, Output Shaft Seal.
- Using the special tools, install the new output shaft seal. Use Special Service Tool: 205-1018 Installation Tube., 307-782 Installer, Output Shaft Seal.
Four-Wheel Drive (4WD) vehicles
- Install the transfer case assembly. Refer to: Transfer Case
.
Rear Wheel Drive (RWD) vehicles
-
NOTE: If the output shaft or output shaft flange are replaced with new parts, align lazer applied ink marks.
Align the index marks marks made during removal.
- Install the new output shaft flange retaining nut.
Torque: 59 lb.ft (80 Nm)
- After installing the new output shaft flange retaining nut, stake the slots to prevent it from coming loose. Use the General Equipment: Punch
- Install the rear driveshaft. Refer to: Rear Driveshaft
.
All vehicles
- Check the transmission fluid level. Refer to: Transmission Fluid Level Check .