LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 580 (Rear Drive Axle/Differential - Vehicles With: Ford 9.75 Inch Ring Gear) >> Removal And Installation >> Axle Shaft - Vehicle With: 3/4 Floating Axle >> Installation

Axle Shaft - Vehicle With: 3/4 Floating Axle: Installation

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: The seal is to be reused unless damaged.

    1. Lubricate the axle shaft seal lip with grease.

      Material

      : Grease (ESA-M1C75-B)

    2. Using special tools, install the new axle shaft seal if it is damaged.Use Special Service Tool: 205-381 (T97T-1177-A) Installer, Rear Axle Oil Seal., 205-153 (T80T-4000-W) Handle.

    GFD816625Courtesy of FORD MOTOR COMPANY
  2. Before installing a new sensor, inspect the sensor housing to make sure the sensor cavity is clean and free of foreign material.
    GFD816626Courtesy of FORD MOTOR COMPANY
  3. To install, reverse the removal procedure.
  4. Check and top off the differential fluid. Refer to: Differential Fluid Level Check .
scientia non olet · About LEMON Manuals