Cooler Bypass Valve - Raptor: Installation

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Install and lubricate a new cooler bypass valve O-ring seal.
Material: Motorcraft® MERCON® ULV Automatic Transmission Fluid / XT-12-QULV (WSS-M2C949-A,) (MERCON® ULV)

Courtesy of FORD MOTOR COMPANY
Install the cooler bypass valve and the bolts.
Torque: 106 lb.in (12 Nm)

Courtesy of FORD MOTOR COMPANY
Inspect and lubricate the band seal and backing ring. Install a new band seal and backing ring if necessary.
1. Backing ring (7J324).
2. Seal (7D285).
  Material: Motorcraft® MERCON® ULV Automatic Transmission Fluid / XT-12-QULV (WSS-M2C949-A,) (MERCON® ULV)
Courtesy of FORD MOTOR COMPANY
Connect the cooler bypass valve-to-transmission tube and install the bolt.
Torque: 89 lb.in (10 Nm)

Courtesy of FORD MOTOR COMPANY
Connect the transmission fluid cooler tubes.

Courtesy of FORD MOTOR COMPANY
Install the transmission fluid tube secondary latches.

Courtesy of FORD MOTOR COMPANY
If equipped, install the skid plate and the bolts.
Torque: 22 lb.ft (30 Nm)

Courtesy of FORD MOTOR COMPANY
Check the transmission fluid level and adjust as necessary. Refer to: Transmission Fluid Level Check .