LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 344 (Rear Drive Axle/Differential - Vehicles With: Ford 8.8 Inch Ring Gear) >> Diagnosis And Testing >> Rear Drive Axle and Differential >> Symptom Chart(s) >> Symptom Chart: NVH

Symptom Chart: NVH

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
Condition Possible Sources Actions
Axle howling or whine Axle lubricant low CHECK the lubricant level. FILL the axle to specification. REFER to: Differential Fluid Level Check .
Axle housing damage INSPECT and INSTALL a new axle assembly as necessary. REFER to: Axle Assembly .
Damaged, worn or incorrect ring and pinion gear contact INSPECT and INSTALL a new ring and pinion set as necessary. Refer to, Contact Pattern , or REFER to: Drive Pinion .
Driveline clunk - loud clunk when shifting from REVERSE to DRIVE Incorrect axle lubricant level CHECK the lubricant level. FILL the axle to specification. REFER to: Differential Fluid Level Check .
Excessive backlash in the axle CHECK for excessive axle backlash. ADJUST backlash as necessary. REFER to: Ring Gear Backlash Adjustment .
Driveline clunk -- occurs as the vehicle starts to move forward following a stop Pinion gears CHECK and REPLACE as necessary. REFER to: Differential Carrier . REFER to: Differential Carrier - Vehicles With: Electronic Locking Differential (ELD) .
Grinding, popping or chattering - noise from the rear axle when the vehicle is turning Damaged or worn differential (differential side gears and pinion gears) INSPECT the differential carrier and the components of the differential carrier. INSTALL a new differential carrier and/or differential carrier components as necessary. REFER to: Differential Carrier . REFER to: Differential Carrier - Vehicles With: Electronic Locking Differential (ELD) .
Grunting -- normally associated with a shudder experienced during acceleration from a complete stop Loose rear axle mount bolts or suspension fasteners CHECK for loose bolts. TIGHTEN to specifications. REFER to: Axle Assembly .
Howl - can occur at various speeds and driving conditions. Affected by acceleration and deceleration Incorrect ring and pinion contact, incorrect bearing preload or gear damage INSPECT and ADJUST as necessary. Refer to, Contact Pattern , or REFER to: Differential Carrier . REFER to: Differential Carrier - Vehicles With: Electronic Locking Differential (ELD) . REFER to: Ring Gear Backlash Adjustment .
Chuckle - heard at coast/ deceleration. Also described as knock Incorrect ring and pinion contact or damaged teeth on the coast side of the ring and pinion INSPECT and INSTALL a new ring and pinion set as necessary. Refer to, Contact Pattern , or REFER to: Drive Pinion .
Knock - noise occurs at various speeds. Not affected by acceleration or deceleration Gear tooth damage to the driver side of the ring and pinion INSPECT and INSTALL a new ring and pinion as necessary. REFER to: Drive Pinion . REFER to: Differential Carrier . REFER to: Differential Carrier - Vehicles With: Electronic Locking Differential (ELD) .
Scraping noise - a continuous low pitched noise starting at low speed Worn or damaged pinion bearings INSPECT and INSTALL new pinion bearings as necessary. REFER to: Drive Pinion Front Bearing .
Driveline shudder - occurs during acceleration from a slow speed or stop Rear drive axle assembly mispositioned CHECK the axle mounts and the rear suspension for damage or wear. Repair as necessary. REFER to: Axle Assembly .
Loose rear axle bolts CHECK the rear axle for loose bolts. TIGHTEN the bolts as necessary. REFER to: Axle Assembly .
Driveline angles out of specification CHECK for correct driveline angles. REFER to: Driveshaft Angle Measurement .