Fuel Tank Filler Pipe - Vehicles With: Aft of Axle Fuel Tank: Removal
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty and 2019 Ford F-450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
For information on Ford Color Coded Illustrations refer to OEM Color Coding
NOTE:
Fuel systems will vary in configuration with different wheelbases. Typical application shown.
NOTE:
Removal steps in this procedure may contain installation details.
- With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- Disconnect the battery ground cable. Refer to: Battery Disconnect and Connect .
- Drain the fuel tank until the fuel level is at or below half of a tank. Refer to: Fuel Tank Draining .
-
NOTE: Typical application shown.
Remove the 3 screws from the filler pipe. Position the fuel filler pipe out of the fuel filler opening or bracket.
Torque: 106 lb.in (12 Nm)
-
NOTE: Typical application shown.
Using a suitable lifting and lowering tool, support the fuel tank. Remove the fuel tank strap bolts and partially lower the fuel tank for access.
Torque: 66 lb.ft (90 Nm)
-
NOTE: Typical application shown.
Loosen the hose clamps and disconnect the fuel tank filler pipe and vent hose from the fuel tank. Remove the fuel tank filler pipe.
Torque: 44 lb.in (5 Nm)