Pinpoint Tests: Notes
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
The Rear Parking Aid Camera Is Inoperative - Vehicles With Rear Only Parking Aid Camera
Refer to Parking Aid for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Parking Aid - System Operation and Component Description .
BCM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B115E:01 | Camera Module: General Electrical Failure | A continuous and on-demand DTC that sets in the BCM when an internal electrical failure is detected from the rear parking aid camera. |
| B115E:02 | Camera Module: General Signal Failure | A continuous and on-demand DTC that sets in the BCM when invalid LIN data is received from the rear parking aid camera. |
| B115E:08 | Camera Module: Bus Signal/Message Failure | A continuous and on-demand DTC that sets in the BCM when there is a LIN communication fault from the rear parking aid camera. |
APIM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| C1001:01 | Vision System Camera: General Electrical Failure | A continuous and on-demand DTC that sets in the APIM when no video signal is detected from the rear parking aid camera with the vehicle in REVERSE. |
FCDIM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| C1001:01 | Vision System Camera: General Electrical Failure | A continuous and on-demand DTC that sets in the FCDIM when no video signal is detected from the rear parking aid camera with the vehicle in REVERSE. |
Possible Causes
- Fuse
- Wiring, terminals or connectors
- Communication network concern
- Rear parking aid camera
- TR input concern
- Infotainment display concern
- LIN concern
- BCM
Visual Inspection and Diagnostic Pre-Checks
- BJB fuse 34 (10A).
- Verify the tailgate is fully closed.
- If the rear parking aid camera is not configured after replacement, some video functions will be inoperative. Verify the rear parking aid camera configuration using the diagnostic scan tool.
NOTE:
Before disconnecting the parking aid camera, verify that the connector is properly seated and latched.