LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation, Message Center And Warning Chimes (2 Of 2) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test Am: The Auto High Beam RTT (RECONFIGURABLE Telltale) Is Never Or Always On

Pinpoint Test Am: The Auto High Beam RTT (RECONFIGURABLE Telltale) Is Never Or Always On

  1. Normal Operation and Fault Conditions 

    See Auto High Beam RTT. REFER to: Message Center - System Operation and Component Description .

    If the auto high beam status display message is missing for less than 5 seconds, the IPC defaults the auto high beam RTT to its last indication state (on or off), based upon the last message received.

    If the auto high beam status display message is missing for 5 seconds or longer, the IPC defaults the high beam RTT off.

    Possible Sources 

    • Communication concern
    • GWM
    • IPMA
    • IPC

  2. AM1 CHECK THE MESSAGE CENTER OPERATION

    • Ignition ON.

    • Close all doors and the hood.

    • Clear all message center warnings by pressing the OK button for each warning present.

    • NOTE: If multiple warnings are present, the message center cycles through each of the warning indicators. Allow the message center to cycle through each display while determining whether the door ajar message center warning is active.

      Monitor the door ajar message center warning.

    • Open the driver door.

    • Clear the message center popup warning.

    • Monitor the door ajar message center warning.

    Does the driver door ajar message center warning turn off with the driver door closed and turn on with the driver door open? 

    Yes  GO to  AM2
    No  GO to Pinpoint Test S 

  3. AM2 CHECK OPERATION OF THE AUTO HIGH BEAMS

    • Verify operation of the auto high beams.

    Do the auto high beams operate correctly? 

    Yes  GO to  AM3
    No  REFER to: Headlamps .

  4. AM3 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

    • Using a diagnostic scan tool, perform the IPC self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to DTC Chart: IPC .
    No  GO to  AM4

  5. AM4 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (CMDTCs).

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Communications Network .
    No  GO to  AM5

  6. AM5 PERFORM THE IPMA (IMAGE PROCESSING MODULE A) SELF-TEST

    • Using a diagnostic scan tool, perform the IPMA self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Lane Keeping System .
    No  INSTALL a new IPC. Refer to Instrument Panel Cluster (IPC) 
scientia non olet · About LEMON Manuals