Pinpoint Test I: U300A:01: Notes
Refer to Power Distribution/BCM for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Steering Wheel and Column Electrical Components - System Operation and Component Description .
BCM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U300A:01 | Ignition Switch: General Electrical Failure | Sets when the BCM detects an invalid combination from the ignition switch input circuits, such as a voltage signal only from the ON-designated circuit, a voltage signal only from the START-designated circuit or a voltage signal from ACC and START-designated circuits at the same time. |
Possible Causes
- Wiring, terminals or connectors
- Ignition switch
- BCM