LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Instrumentation, Message Center And Warning Chimes (2 Of 2) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test An: The Cruise Control Set Speed Display Or Cruise Control RECONFIGURABLE Telltale (RTT) Is Never On

Pinpoint Test An: The Cruise Control Set Speed Display Or Cruise Control RECONFIGURABLE Telltale (RTT) Is Never On

  1. Normal Operation and Fault Conditions 

    See Cruise Control Reconfigurable Telltale (RTT). REFER to: Message Center - System Operation and Component Description .

    If the cruise control status display or cruise control set speed display message is missing for less than 5 seconds, the IPC defaults the cruise control set speed display or cruise control RTT indicator to its last indication state (on or off) based upon the last message received.

    If the cruise control status display or cruise control set speed display message is missing for 5 seconds or longer, the IPC defaults the cruise control set speed display or cruise control RTT indicator off.

    Possible Sources 

    • Cruise control concern
    • Communication concern
    • GWM concern
    • IPC

    Visual Inspection and Pre-checks 

    • Make sure to verify the cruise control Reconfigurable Telltale (RTT) with the engine running. The indicator may not display with the KOEO.

  2. AN1 CHECK THE MESSAGE CENTER OPERATION

    • Ignition ON.

    • Close all doors and the hood.

    • Clear all message center warnings by pressing the OK button for each warning present.

    • NOTE: If multiple warnings are present, the message center cycles through each of the warning indicators. Allow the message center to cycle through each display while determining whether the door ajar message center warning is active.

      Monitor the door ajar message center warning.

    • Open the driver door.

    • Clear the message center popup warning.

    • Monitor the door ajar message center warning.

    Does the driver door ajar message center warning turn off with the driver door closed and turn on with the driver door open? 

    Yes  GO to  AN2
    No  GO to Pinpoint Test S 

  3. AN2 CHECK OPERATION OF THE CRUISE CONTROL SYSTEM

    • Verify operation of the cruise control system.

    Does the cruise control system operate correctly? 

    Yes  GO to  AN3
    No  For base cruise control, REFER to CRUISE CONTROL . For ACC, REFER to: CRUISE CONTROL - Vehicles With: Adaptive Cruise Control/Intelligent Adaptive Cruise Control .

  4. AN3 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

    • Using a diagnostic scan tool, perform the IPC self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to DTC Chart: IPC .
    No  GO to  AN4

  5. AN4 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (CMDTCs).

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Communications Network .
    No  INSTALL a new IPC. Refer to Instrument Panel Cluster (IPC) 
scientia non olet · About LEMON Manuals