Transmission - 2.3L EcoBoost (231kW/314PS)/2.3L EcoBoost (257kW/350PS) - MI4
WARNING: This page is about a different variant/trim than selected.
For information on Ford Color Coded Illustrations refer to OEM COLOR CODING
Special Tool(s) / General Equipment
| Transmission Jack |
|---|
WARNING:
Do not breathe dust or use compressed air to blow dust from storage containers or friction components. Remove dust using government-approved techniques. Friction component dust may be a cancer and lung disease hazard. Exposure to potentially hazardous components may occur if dusts are created during repair of friction components, such as brake pads and clutch discs. Exposure may also cause irritation to skin, eyes and respiratory tract, and may cause allergic reactions and/or may lead to other chronic health effects. If irritation persists, seek medical attention or advice. Failure to follow these instructions may result in serious personal injury.
- Disconnect the battery. Refer to: Battery Disconnect and Connect .
-
NOTE: Support the transmission with a transmission jack for gearshift lever removal.
Remove the gearshift lever. Refer to: Gearshift Lever
Use the General Equipment: Transmission Jack
- Remove the bolts and remove the transmission support insulator and crossmember from the back of the transmission.
- Remove the starter motor. Refer to: Starter Motor .
- Disconnect the electrical connectors and the wiring retainers and position the vehicle wiring harness aside.
- Remove the catalytic converter support bracket bolts.
- Remove the bolt and the inspection cover.
-
NOTE: If disassembly of the transmission is required, drain the transmission fluid.
Remove the drain plug and drain the transmission fluid.
Torque: 26 lb.ft (35 Nm)
- Remove the retainer and disconnect the hydraulic tube from the clutch master cylinder.
- Remove the retainer and position the coolant tube bracket aside.
-
NOTE: Secure the transmission with a safety strap to the transmission jack.
Remove the bellhousing bolts, pull the transmission back to remove the input shaft from the clutch, lower the transmission and remove it from the vehicle.