Diagnostic Trouble Code (DTC) Chart
WARNING: This page is about a different variant/trim than selected.
| Module | DTC | Description | Action |
|---|---|---|---|
| ABS | U0401:00 | Invalid Data Received from ECM/PCM A: No Sub Type Information | GO to Pinpoint Test B |
| PAM | U0401:00 | Invalid Data Received from ECM/PCM A: No Sub Type Information | GO to Pinpoint Test B |
| PCM | P0720:00 | Output Shaft Speed Sensor Circuit: No Sub Type Information | GO to Pinpoint Test D |
| PCM | P0721:00 | Output Shaft Speed Sensor Circuit Range/Performance: No Sub Type Information | GO to Pinpoint Test D |
| PCM | P0722:00 | Output Shaft Speed Sensor Circuit No Signal: No Sub Type Information | GO to Pinpoint Test D |
| PCM | P086A:00 | Neutral Position Sensor 'A' Circuit/Open: No Sub Type Information | GO to Pinpoint Test B |
| PCM | P086B:00 | Neutral Position Sensor 'A' Circuit Range/Performance: No Sub Type Information | GO to Pinpoint Test A |
| PCM | P086C:00 | Neutral Position Sensor 'A' Circuit Low: No Sub Type Information | GO to Pinpoint Test A |
| PCM | P086D:00 | Neutral Position Sensor 'A' Circuit High: No Sub Type Information | GO to Pinpoint Test A |
| PCM | P086E:00 | Neutral Position Sensor 'A' Circuit Intermittent/Erratic: No Sub Type Information | GO to Pinpoint Test B |
| PCM | P08AE:00 | Neutral Position Sensor 'B' Circuit Range/Performance: No Sub Type Information | GO to Pinpoint Test A |
| PCM | P08AF:00 | Neutral Position Sensor 'B' Circuit Low: No Sub Type Information | GO to Pinpoint Test A |
| PCM | P08B0:00 | Neutral Position Sensor 'B' Circuit High: No Sub Type Information | GO to Pinpoint Test A |
| PCM | P08B2:00 | Neutral Position Sensor 'A'/'B' Correlation: No Sub Type Information | GO to Pinpoint Test C |
| PCM | P095A:00 | Gear Shift Position Circuit 'C': No Sub Type Information | GO to Pinpoint Test A |
| PCM | P095B:00 | Gear Shift Position Circuit 'C' Range/Performance: No Sub Type Information | GO to Pinpoint Test B |
| PCM | P095C:00 | Gear Shift Position Circuit 'C' Low: No Sub Type Information | GO to Pinpoint Test A |
| PCM | P095D:00 | Gear Shift Position Circuit 'C' High: No Sub Type Information | GO to Pinpoint Test A |