Transmission Control Module (TCM): Installation
WARNING: This page is about a different variant/trim than selected.
- To install, reverse the removal procedure.
- Using a diagnostic scan tool, complete the PMI process for the TCM following the on-screen instructions
- If a new TCM was installed, the TCM must be programmed with the Transmission Identification (TRID) data. The 11-digit TRID number can be found on the transmission barcode label on the right side of the transmission case. Using the diagnostic scan tool, carry out the following routine(s): Transmission Characterization/Solenoid IDN (identification number). Refer to: Transmission Strategy Download