Pinpoint Test F: Rattle During Light Acceleration From A Low Speed In Any Gear

WARNING: This page is about a different variant/trim than selected.

Normal Operation and Fault Conditions
- Clutch, input shaft, clutch actuator, engagement bearing
  - Drive the vehicle and attempt to duplicate the noise by coasting in the gear of interest. Load the clutch by pressing lightly on the accelerator. If excessive noise occurs, INSTALL a new transmission. REFER to: Transmission
Possible Sources
- Clutch
- Input shaft
- Clutch actuator
- Engagement bearing
Diagnostic steps are not provided for this symptom or DTC. REFER to: Diagnostic Methods