Pinpoint Test B: Noise, Vibration Or Harshness (NVH) In Reverse, 2ND, 4TH Or 6TH Gear
WARNING: This page is about a different variant/trim than selected.
- Normal Operation and Fault Conditions
- Even clutch, even clutch shaft
- Driving normally, shift into the affected gears. Cruise at various steady speeds in the affected gears. Try upshifts with various throttle openings (usually in 15-35% range), and downshifts by decelerating the vehicle with various loads on the brake pedal. If the transmission NVH is excessive, INSTALL a new transmission. REFER to: Transmission
Possible Sources
- Even clutch
- Even clutch shaft
- Even clutch, even clutch shaft
Diagnostic steps are not provided for this symptom or DTC. REFER to: Diagnostic Methods