LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> Transit-250 Base, Van Cargo Extended, 3.5L Eng VIN 8, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Starting System - 3.5L ECOBOOST (235KW/320PS)) >> Diagnosis And Testing >> Starting System >> Pinpoint Tests >> Pinpoint Test E: DTC P06E4

Pinpoint Test E: DTC P06E4

WARNING: This page is about a different variant/trim than selected.
  1. Refer to Electronic Engine Controls - 3.5L GTDI for schematic and connector information.

    DTC Fault Trigger Conditions 

    DTC Description Fault Trigger Condition
    PCM P06E4:00 Control Module Wake-up Circuit Performance: No Sub Type Information This DTC sets when the PCM detects control module Wake-up circuit performance.

    Possible Sources 

    • PCM
    • Wiring, terminals or connectors

  2. E1 RETRIEVE DIAGNOSTIC TROUBLE CODES (DTCS)

    • Ignition ON.

    • Using a diagnostic scan tool, perform PCM self-tests.

    Is DTC P06E4 recorded? 

    Yes  RETRIEVE and RECORD all CMDTCs. If BCM DTC C113A:11 or C113A:15 is found, GO to Pinpoint Test C  Clear all Diagnostic Trouble Codes (DTCs). RERUN the PCM self-test. If the DTC returns, CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If no Technical Service Bulletins (TSBs) address this concern, PCM GUIDED ROUTINE TESTING
    No  The repair is completed.
scientia non olet · About LEMON Manuals