Pinpoint Test Ad: The Stability-Traction Control Disabled Indicator (Sliding Car Off Icon) Is Never Or Always On
- Normal Operation and Fault Conditions
See Stability-Traction Control Disabled Indicator (Sliding Car OFF Icon). REFER to: Instrument Panel Cluster (IPC) - System Operation and Component Description .
If the stability-traction control disabled indicator request message is missing or invalid for less than 5 seconds, the IPC defaults the stability-traction control indicator (sliding car icon) to the last indication state (on or off), based upon the last message received.
If the stability-traction control disabled indicator request message is missing for 5 seconds or longer, the IPC defaults the stability-traction control disabled indicator (sliding car OFF icon) on.
Possible Sources
- MyKey® programmed key in use
- Stability-traction control system concern
- Stability-traction control system cannot be disabled
- Communication concern
- ABS concern
- GWM concern
- IPC
- NOTE: When a MyKey® programmed key is in use and the AdvanceTrac® on feature is configured always on, the traction control system cannot be disabled and the traction control indicator does not turn on when the traction control disable button is pressed. The traction control indicator still functions correctly to indicate a traction control system fault and a traction control active event.
- AD1 CARRY OUT THE IPC (INSTRUMENT PANEL CLUSTER) INDICATOR LAMP CONTROL ACTIVE COMMAND USING A DIAGNOSTIC SCAN TOOL
- Using a diagnostic scan tool, view the IPC Parameter Identifications (PIDs).
- Access the IPC and control the STAB_TC_LMPPID
- Command the stability-traction control disabled indicator (sliding car OFF icon) on and off while observing the stability-traction control disabled indicator (sliding car OFF icon).
Does the stability-traction control disabled indicator (sliding car OFF icon) illuminate when commanded on and turn off when commanded off?
Yes GO to AD2 No Install a new IPC. Refer to Instrument Panel Cluster (IPC) . - AD2 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Ignition ON.
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to DTC Chart: IPC in Diagnostic Trouble Code (DTC) Chart . No GO to AD3 - AD3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (CMDTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Communications Network . No GO to AD4 - AD4 CHECK FOR KEY TYPE
- Check if the key is a MyKey® programmed key or an administrator key. Refer to the Owner's Literature.
Is the key an administrator key?
Yes GO to AD6 No GO to AD5 - AD5 CHECK FOR THE TRACTION CONTROL FEATURE CONFIGURED ALWAYS ON
- Check if the traction control feature is configured always on. Refer to the Owner's Literature.
Is the traction control feature configured always on?
Yes The traction control system cannot be disabled when the feature is configured always on. No GO to AD6 - AD6 CHECK THE TRACTION CONTROL SETTING
- In the message center, navigate to the traction control setting menu and observe the traction control setting using the RH steering wheel switch and an administrator key while enabling the stability-traction control on then off again.
Does the traction control selection change when the feature is configured on and off?
Yes The system is operating correctly at this time. No DIAGNOSE the stability-traction control cannot be disabled. REFER to: Anti-Lock Brake System (ABS) and Stability Control .