Pinpoint Test H : P060C:41, P060C:42, P060C:44, P060C:47, P1A0E:61
- Normal Operation and Fault Conditions
REFER to: Electric Powertrain Control - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition SOBDMC P060C:41 Internal Control Module Main Processor Performance: General Checksum Failure This DTC sets when an internal error occurs. SOBDMC P060C:42 Internal Control Module Main Processor Performance: General Memory Failure This DTC sets when an internal error occurs. SOBDMC P060C:44 Internal Control Module Main Processor Performance: Data Memory Failure This DTC sets when an internal error occurs. SOBDMC P060C:47 Internal Control Module Main Processor Performance: Watchdog/Safety μC Failure This DTC sets when an internal error occurs. SOBDMC P1A0E:61 Hybrid Powertrain Control Module - Motor Disabled: Signal Calculation Failure This DTC sets when a plausibility fault with motor torque is detected. Possible Sources
- Inverter System Controller (ISC) calibration
- Inverter System Controller (ISC)
- H1 CHECK FOR INVERTER SYSTEM CONTROLLER (ISC) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, perform the Inverter System Controller (ISC) self-test.
Are any Inverter System Controller (ISC) DTCs other than P060C:41, P060C:42, P060C:44, P060C:47 or P1A0E:61 present?
Yes DIAGNOSE all other Inverter System Controller (ISC) DTCs, REFER to the Diagnostic Trouble Code (DTC) Chart . No For DTC P060C:41, P060C:42, P060C:44, P060C:47 or P1A0E:61 only GO to H2 - H2 VERIFY ALL CAN MODULE CALIBRATION LEVELS
- Verify all CAN modules are at the latest calibration level.
Are all CAN modules are at the latest calibration level?
Yes GO to H3 No UPDATE the Inverter System Controller (ISC) to the latest calibration level. - H3 CLEAR AND CHECK THE INVERTER SYSTEM CONTROLLER (ISC) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, clear the Inverter System Controller (ISC) DTCs.
- Using a diagnostic scan tool, perform the Inverter System Controller (ISC) self-test.
Are DTCs P060C:41, P060C:42, P060C:44, P060C:47 or P1A0E:61 present in the Inverter System Controller (ISC)?
Yes CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new Inverter System Controller (ISC). REFER to: Inverter System Controller [SOBDMC] . No The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.