LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> Explorer Limited Hybrid, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Electronic Engine Controls - 3.3L DURATEC-V6 3.3L DURATEC-V6 - Hybrid (BP)) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation

Powertrain Control Module (PCM): Installation

WARNING: This page is about a different variant/trim than selected.
  1. To install, reverse the removal procedure.
  2. NOTE: This step is only necessary when installing a new component.

    Upload the module information from the diagnostic tool using the Programmable Modules Installation routine. Refer to: Module Programming .

  3. NOTE: This step is only necessary when installing a new component.

    Carry out the Parameter Reset procedure. Refer to: Anti-Theft Key Programming - Scan Tool .

  4. NOTE: This step is only necessary when installing a new component.

    Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.

scientia non olet · About LEMON Manuals