LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> Explorer Limited Hybrid, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 728 (Automatic Transmission - 10-Speed Automatic Transmission - 10R80 (2 Of 2)) >> Diagnosis And Testing >> Torque Converter Clutch (TCC) >> Symptom Chart

Symptom Chart

WARNING: This page is about a different car, the 2021 Ford Police Interceptor Utility. However, it is still accessible from the selected car via links, so may be relevant.

Torque Converter Clutch (TCC) 

For torque converter operation, REFER to: Torque Converter .

Condition Possible Sources Action
TCC does not apply TCC solenoid mechanically stuck OFF INSTALL a new TCC solenoid. REFER to: Shift Solenoids (SS) .
TCC priority valve stuck OFF DISASSEMBLE, CLEAN and INSPECT the TCC priority valve. If the bore, valve or spring is damaged, INSTALL a new main control valve body. REFER to: Main Control Valve Body .
TCC regulator valve stuck OFF DISASSEMBLE, CLEAN and INSPECT the TCC regulator valve. If the bore or valve is damaged, INSTALL a new main control valve body. REFER to: Main Control Valve Body .
TCC damper missing or damaged. DISASSEMBLE, CLEAN and INSPECT the TCC damper. If the damper is missing or damaged, INSTALL a new main control valve body. REFER to: Main Control Valve Body .
Converter feed blow-off valve missing or damaged DISASSEMBLE, CLEAN and INSPECT the converter feed blow-off valve. If the valve is missing or damaged, INSTALL a new main control valve body. REFER to: Main Control Valve Body .
CONV FD, MDA-TCC, APPLY, REL hydraulic circuit blocked or leaking DISASSEMBLE and INSPECT the main control valve body and separator plate passages for debris, blockage and leaks. CLEAN as necessary. REFER to: Main Control Valve Body .
REMOVE and INSPECT the front support assembly and input shaft Teflon seals for damage, blockage and leaks. REFER to: Torque Converter . INSTALL new components as necessary. REFER to: Transmission .
TCC friction material worn or damaged INSTALL a new torque converter. REFER to: Transmission - 3. 3L Duratec-V6 . REFER to: Transmission - 3. 0L EcoBoost .
TCC always applied/stalls vehicle TCC solenoid mechanically stuck ON INSTALL a new TCC solenoid. REFER to: Shift Solenoids (SS) .
TCC priority valve stuck ON DISASSEMBLE, CLEAN and INSPECT the TCC priority valve. If the bore or valve is damaged, INSTALL a new main control valve body. REFER to: Main Control Valve Body .
TCC regulator valve stuck ON DISASSEMBLE, CLEAN and INSPECT the TCC regulator valve. If the bore or valve is damaged, INSTALL a new main control valve body. REFER to: Main Control Valve Body .
CONV FD, MDA-TCC, APPLY, REL hydraulic circuit cross leaks DISASSEMBLE and INSPECT the main control valve body and separator plate passages for cracks, warping, and damage. If damage is found, INSTALL a new main control valve body. REFER to: Main Control Valve Body .
REMOVE and INSPECT the front support assembly and input shaft Teflon seals for damage, blockage and leaks. REFER to: Torque Converter . INSTALL new components as necessary. REFER to: Transmission .
TCC friction material worn or damaged INSTALL a new torque converter. REFER to: Transmission - 3. 3L Duratec-V6 . REFER to: Transmission - 3. 0L EcoBoost .
TCC cycles, shudders or chatters Incorrect transmission strategy programmed into the TCM CARRY OUT the transmission strategy download and the adaptive learning drive cycle. REFER to: Transmission Strategy Download . REFER to: Adaptive Learning Drive Cycle .
TCC solenoid mechanically sticking INSTALL a new TCC solenoid. REFER to: Shift Solenoids (SS) .
TCC priority valve sticking DISASSEMBLE, CLEAN and INSPECT the TCC priority valve. If the bore, valve or spring is damaged, INSTALL a new main control valve body. REFER to: Main Control Valve Body .
TCC Regulator Valve sticking DISASSEMBLE, CLEAN and INSPECT the regulator valve. If bore or valve is damaged, INSTALL a new main control valve body. REFER to: Main Control Valve Body .
CONV FD, MDA-TCC, APPLY, REL hydraulic circuit blocked or leaking DISASSEMBLE and INSPECT the main control valve body and separator plate passages for debris, blockage and leaks. CLEAN as necessary. REFER to: Main Control Valve Body .
REMOVE and INSPECT the front support assembly and input shaft Teflon seals for damage, blockage and leaks. REFER to: Torque Converter . INSTALL new components as necessary. REFER to: Transmission .
TCC friction material worn or damaged INSTALL a new torque converter. REFER to: Transmission - 3. 3L Duratec-V6 . REFER to: Transmission - 3. 0L EcoBoost .