LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> Escape Titanium Plug-In Hybrid >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation, Message Center And Warning Chimes (2 Of 2) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test Cc: The Blind Spot Information System (BLIS®)/Cross Traffic Alert (CTA) Warning Chime Is Inoperative

Pinpoint Test Cc: The Blind Spot Information System (BLIS®)/Cross Traffic Alert (CTA) Warning Chime Is Inoperative

  1. Normal Operation and Fault Conditions 

    See BLIS/ CTA Warning Chime. REFER to: Warning Chimes - System Operation and Component Description .

    Possible Sources 

    • Communication concern
    • BLIS/ CTA concern
    • GWM
    • IPC

  2. CC1 CHECK THE SEATBELT WARNING CHIME OPERATION

    • Ignition OFF.

    • Ignition ON.

    • Unbuckle the driver seatbelt.

    • Monitor the seatbelt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.

    Does the seatbelt warning chime operate for approximately 6 seconds? 

    Yes  GO to  CC2
    No  GO to Pinpoint Test CR 

  3. CC2 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

    • Using a diagnostic scan tool, perform the IPC self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to the IPC DTC Chart.
    No  GO to  CC3

  4. CC3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Communications Network
    No  DIAGNOSE the Blind Spot Information System (BLIS®)/Cross Traffic Alert (CTA) system. REFER to: Blind Spot Information System
scientia non olet · About LEMON Manuals