Pinpoint Test S: DTC (Diagnostic Trouble Code) B124E:11, B124E:13, B124E:55, B124E:96 Or B124E:9E
- Refer to WIPERS AND WASHERS
for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Wipers and Washers - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition SCCM B124E:11 Wiper Stalk Switch Pack: Circuit Short To Ground Sets when the SCCM detects a short to ground from the wiper stalk switch pack. SCCM B124E:13 Wiper Stalk Switch Pack: Circuit Open Sets when the SCCM detects an open circuit from the wiper stalk switch pack. SCCM B124E:55 Wiper Stalk Switch Pack: Not Configured Sets when the SCCM detects an improper or unexpected signal from the wiper stalk switch pack. SCCM B124E:96 Wiper Stalk Switch Pack: Component Internal Failure Sets when the SCCM detects an improper or unexpected signal from the wiper stalk switch pack. SCCM B124E:9E Wiper Stalk Switch Pack: Stuck On Sets when the SCCM detects an improper or unexpected signal from the wiper stalk switch pack. Possible Sources
- Wiring, terminals or connectors
- Wiper/washer switch
- SCCM
Visual Inspection and Pre-checks
- Verify BJB fuse 69 (30A) is OK.
- NOTE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
- S1 CHECK FOR SCCM (STEERING COLUMN CONTROL MODULE) DTC (DIAGNOSTIC TROUBLE CODE) B124E:11, B124E:13, B124E:55, B124E:96 OR B124E:9E
- Ignition ON.
- Using a diagnostic scan tool, carry out the SCCM self-test.
Is DTC B124E:11, B124E:13, B124E:55, B124E:96 OR B124E:9E present?
Yes REMOVE the Wiper Stalk Switch Pack and inspect the pins and terminals for damage and corrosion and repair as needed. If ok, INSTALL a new Wiper Stalk Switch Pack REFER to: Wipers and Washers ..CLEAR the DTC and RETEST. If the DTC returns, CHECK OASIS for any applicable service articles: TSB, GSB, SSM, or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new SCCM. REFER to: Wipers and Washers No The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.