DTC U2100 - Control Module Configuration Incompatible
WARNING: This page is about a different variant/trim than selected.
DTC DESCRIPTION U2100 - CONTROL MODULE CONFIGURATION INCOMPATIBLE
| Description: | This DTC sets when the PCM RAM has been corrupted. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Reprogram or update the calibration. Check for other DTCs or drive symptoms for further action. Check for aftermarket performance products. If necessary to install new PCM. Refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) , Programming the VID Block for a replacement PCM. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. | ||