LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion Titanium Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 76 (Engine Controls - Powertrain DTC Descriptions (Except Diesel & Hybrid) - DTC P2163 - P3404, DTC PXXXX, DTC U0046 - U300C, DTC UXXXX) >> DTC P2227 - Barometric Pressure Sensor A Circuit Range/Performance

DTC P2227 - Barometric Pressure Sensor A Circuit Range/Performance

WARNING: This page is about a different variant/trim than selected.
DTC DESCRIPTION P2227 - BAROMETRIC PRESSURE SENSOR A CIRCUIT RANGE/PERFORMANCE

For Vehicles With 2.7L, 3.0L, And 3.5L GTDI Engines 
Description:  This DTC sets when either of the following conditions are present.
When the BARO PID does not correlate with the TCBP and the MAP PIDs at ignition ON, engine OFF.
When the MAP and TCBP PIDs correlate with the engine running, but the TCBP PID does not correlate with the BARO PID at idle.
Possible Causes: 
  • Damaged BARO sensor
  • Damaged PCM
Diagnostic Aids:  This DTC is only operational between 1, 000 feet below sea level to 15, 000 feet above sea level, it should be disregarded if set outside the operational range.
For All Others  
Description:  This DTC sets when the BARO does not correlate with an inferred barometric pressure calculation based on the MAP or mass airflow (MAF) value.
Possible Causes: 
  • Damaged BARO sensor
  • Damaged PCM
Diagnostic Aids:  This DTC is only operational between 1, 000 feet below sea level to 15, 000 feet above sea level, it should be disregarded if set outside the operational range.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST DO .