DTC P144C - EVAP System Purge Flow Performance During Boost

WARNING: This page is about a different variant/trim than selected.

DTC DESCRIPTION P144C - EVAP SYSTEM PURGE FLOW PERFORMANCE DURING BOOST

Description:	The EVAP check valve test is performed during minimal boost conditions, once per drive cycle, when entry conditions are met. This DTC sets when the fuel tank pressure exceeds a calibrated amount within a specified amount of time during the test (single path check valve), or when the fuel tank vacuum is less than a calibrated amount within a specified amount of time or when the fuel tank pressure exceeds a calibrated amount within a specified amount of time during the test (dual path check valve).
Possible Causes:	Restricted EVAP ejector connections at the intake air system Stuck open EVAP check valve Stuck closed EVAP check valve Damaged EVAP ejector Damaged EVAP check valve
Diagnostic Aids:
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	GO to PINPOINT TEST HX .