DTC P0722 - Output Shaft Speed Sensor Circuit No Signal

WARNING: This page is about a different variant/trim than selected.

DTC DESCRIPTION P0722 - OUTPUT SHAFT SPEED SENSOR CIRCUIT NO SIGNAL

Description:	This DTC sets when the OSS sensor signal is missing upon the initial movement of the vehicle.
Possible Causes:	Damaged OSS connector Damaged OSS sensor Incorrectly installed OSS sensor OSS wiring harness intermittent short OSS wiring harness open
Diagnostic Aids:	Check the wiring, connector, and OSS sensor for damage.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
Manual Transmission	GO to PINPOINT TEST DP .
Automatic Transmission	Refer to the Automatic Transmission article, to continue diagnosis.