DTC P0721 - Output Shaft Speed Sensor Circuit Range/Performance

WARNING: This page is about a different variant/trim than selected.

DTC DESCRIPTION P0721 - OUTPUT SHAFT SPEED SENSOR CIRCUIT RANGE/PERFORMANCE

Description:	This DTC sets when the OSS sensor signal input exceeds the calibrated threshold or has excessive electrical noise. The OSS signal is very sensitive to electrical noise. This electrical noise distorts the OSS input to the PCM.
Possible Causes:	Incorrect OSS wiring harness routing Aftermarket accessories OSS wiring damaged OSS wiring insulation wear
Diagnostic Aids:	Check the routing of the OSS wiring harness. Check the OSS wiring and the OSS connector for damage.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
Manual Transmission	GO to PINPOINT TEST DP .
Automatic Transmission	Refer to the Automatic Transmission article, to continue diagnosis.