DTC P0720 - Output Shaft Speed Sensor Circuit
WARNING: This page is about a different variant/trim than selected.
DTC DESCRIPTION P0720 - OUTPUT SHAFT SPEED SENSOR CIRCUIT
| Description: | This DTC sets when the OSS sensor signal input exceeds the calibrated threshold. The OSS sensor provides a signal to the PCM based on the speed of the output shaft of the transmission. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Verify the sensor signal output varies with the vehicle speed. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| Manual Transmission | GO to PINPOINT TEST DP . | ||
| Automatic Transmission | Refer to the Automatic Transmission article, to continue diagnosis. | ||