Pinpoint Test S : DTC B120A:01, B120A:98, B14BB:01, B14BB:11, B14BB:12, B14BB:13, B14BB:1A And B14C0:11

WARNING: WARNING: Incorrect repair techniques or actions can cause an accidental Supplemental Restraint System (SRS) deployment. Never compromise or depart from these instructions. Failure to precisely follow all instructions could result in serious personal injury from an accidental deployment.

S1 CHECK THE RESISTANCE OF THE PASSENGER SEAT CUSHION BLOWER MOTOR THERMO-ELECTRIC DEVICE (TED)

Ignition OFF.

Disconnect: Passenger Cushion Blower Motor C3040.

NOTE: Do not operate the heated/climate seat for 60 minutes before carrying out any diagnostics. Allow the seat to rest for 60 minutes until it has reached ambient temperature.

Measure the component side resistance between:

Positive Lead	Measurement / Action	Negative Lead
Courtesy of FORD MOTOR COMPANY C3040-1, Component Side	Courtesy of FORD MOTOR COMPANY	Courtesy of FORD MOTOR COMPANY C3040-2, Component Side

Is the resistance between 0.9 and 10 ohms?

Yes

GO to S2

No	INSTALL a new cushion blower motor. REFER to: Front Seat Cushion Blower Motor .

S2 CHECK THE RESISTANCE OF THE PASSENGER SEAT CUSHION BLOWER MOTOR

NOTE: The ohmmeter must be connected with the positive lead to pin 3 and the negative lead to pin 4 when measuring. Ohmmeter leads incorrectly connected results in false readings and leads to incorrect identification of components that are not faulty.

Measure the component side resistance between:

Positive Lead	Measurement / Action	Negative Lead
Courtesy of FORD MOTOR COMPANY C3040-3, Component Side	Courtesy of FORD MOTOR COMPANY	Courtesy of FORD MOTOR COMPANY C3040-4, Component Side

Is the resistance between 4, 000 and 10, 000 ohms?

Yes

GO to S3

No	INSTALL a new cushion blower motor. REFER to: Front Seat Cushion Blower Motor .

S3 CHECK THE PASSENGER SEAT CUSHION BLOWER MOTOR SPEED CONTROL AND BLOWER OUTPUT CIRCUITS FOR AN INTERNAL SHORT TOGETHER

Measure the component side resistance between:

Positive Lead	Measurement / Action	Negative Lead
Courtesy of FORD MOTOR COMPANY C3040-3, Component Side	Courtesy of FORD MOTOR COMPANY	Courtesy of FORD MOTOR COMPANY C3040-7, Component Side

Is the resistance greater than 2M ohms?

Yes

GO to S4

No	INSTALL a new cushion blower motor. REFER to: Front Seat Cushion Blower Motor .

S4 CHECK THE PASSENGER SEAT CUSHION BLOWER MOTOR THERMISTOR

Measure the component side resistance between:

Positive Lead	Measurement / Action	Negative Lead
Courtesy of FORD MOTOR COMPANY C3040-5, Component Side	Courtesy of FORD MOTOR COMPANY	Courtesy of FORD MOTOR COMPANY C3040-8, Component Side

Compare the measured resistance value with the following table:

Ambient Temperature	Resistance
0-10 deg. C (32-50 deg. F)	2, 782-1, 663 ohms
10-20 deg. C (50-68 deg. F)	1, 837-1, 140 ohms
20-30 deg. C (68-86 deg. F)	1, 260-806 ohms
30-40 deg. C (86-104 deg. F)	893-570 ohms
40-50 deg. C (104-122 deg. F)	630-428 ohms

Is the resistance within the limits indicated?

Yes

GO to S5

No	INSTALL a new cushion blower motor. REFER to: Front Seat Cushion Blower Motor .

S5 CHECK THE PASSENGER SEAT CUSHION BLOWER MOTOR CIRCUITS FOR A SHORT TO VOLTAGE

WARNING: WARNING: Turn the ignition OFF and wait one minute to deplete the backup power supply. Failure to follow this instruction may result in serious personal injury or death in the event of an accidental deployment.

Ignition OFF.

Disconnect: Driver Side Airbag In-line C3368.

Disconnect: Passenger Side Airbag In-line C3206.

Disconnect: DSM C341D and C341E.

Connect: Passenger Cushion Blower Motor C3040.

Ignition ON.

Measure:

Positive Lead	Measurement / Action	Negative Lead
C341D-3	Courtesy of FORD MOTOR COMPANY	Ground
C341D-2	Courtesy of FORD MOTOR COMPANY	Ground
C341D-10	Courtesy of FORD MOTOR COMPANY	Ground
C341D-11	Courtesy of FORD MOTOR COMPANY	Ground

Measure:

Positive Lead	Measurement / Action	Negative Lead
C341E-4	Courtesy of FORD MOTOR COMPANY	Ground
C341E-2	Courtesy of FORD MOTOR COMPANY	Ground
C341E-7	Courtesy of FORD MOTOR COMPANY	Ground

Are any voltages present?

Yes	REPAIR the affected circuit. GO to S13

GO to S6

S6 CHECK THE PASSENGER SEAT CUSHION BLOWER MOTOR CIRCUITS FOR A SHORT TO GROUND

Ignition OFF.

Measure:

Positive Lead	Measurement / Action	Negative Lead
C341D-3	Courtesy of FORD MOTOR COMPANY	Ground
C341D-2	Courtesy of FORD MOTOR COMPANY	Ground
C341D-10	Courtesy of FORD MOTOR COMPANY	Ground
C341D-11	Courtesy of FORD MOTOR COMPANY	Ground

Measure:

Positive Lead	Measurement / Action	Negative Lead
C341E-4	Courtesy of FORD MOTOR COMPANY	Ground
C341E-2	Courtesy of FORD MOTOR COMPANY	Ground
C341E-7	Courtesy of FORD MOTOR COMPANY	Ground

Are the resistances greater than 10, 000 ohms?

Yes

GO to S9

GO to S7

S7 CHECK THE PASSENGER SEAT CUSHION BLOWER MOTOR CIRCUITS FOR A SHORT TO GROUND WITH THE CUSHION BLOWER MOTOR DISCONNECTED

Disconnect: Passenger Cushion Blower Motor C3040.

Measure:

Positive Lead	Measurement / Action	Negative Lead
C341D-3	Courtesy of FORD MOTOR COMPANY	Ground
C341D-2	Courtesy of FORD MOTOR COMPANY	Ground
C341D-10	Courtesy of FORD MOTOR COMPANY	Ground
C341D-11	Courtesy of FORD MOTOR COMPANY	Ground

Measure:

Positive Lead	Measurement / Action	Negative Lead
C341E-4	Courtesy of FORD MOTOR COMPANY	Ground
C341E-2	Courtesy of FORD MOTOR COMPANY	Ground
C341E-7	Courtesy of FORD MOTOR COMPANY	Ground

Are the resistances greater than 10, 000 ohms?

Yes	INSTALL a new cushion blower motor. REFER to: Front Seat Cushion Blower Motor . GO to S13

GO to S8

S8 CHECK THE PASSENGER SEAT CUSHION BLOWER MOTOR CIRCUITS FOR A SHORT TO GROUND WITH THE BACKREST BLOWER MOTOR DISCONNECTED

Disconnect: Passenger Backrest Blower Motor C3039.

Measure:

Positive Lead	Measurement / Action	Negative Lead
C341D-3	Courtesy of FORD MOTOR COMPANY	Ground
C341D-2	Courtesy of FORD MOTOR COMPANY	Ground
C341D-10	Courtesy of FORD MOTOR COMPANY	Ground
C341D-11	Courtesy of FORD MOTOR COMPANY	Ground

Measure:

Positive Lead	Measurement / Action	Negative Lead
C341E-4	Courtesy of FORD MOTOR COMPANY	Ground
C341E-2	Courtesy of FORD MOTOR COMPANY	Ground
C341E-7	Courtesy of FORD MOTOR COMPANY	Ground

Are the resistances greater than 10, 000 ohms?

Yes	REPAIR the affected circuit. GO to S13

No	INSTALL a new backrest blower motor. REFER to: Front Seat Backrest Blower Motor . GO to S13

S9 CHECK THE PASSENGER SEAT CUSHION BLOWER MOTOR CIRCUITS FOR AN OPEN

Disconnect: Passenger Cushion Blower Motor C3040.

Measure:

Positive Lead	Measurement / Action	Negative Lead
C341D-3	Courtesy of FORD MOTOR COMPANY	C3040-3
C341D-2	Courtesy of FORD MOTOR COMPANY	C3040-1
C341D-10	Courtesy of FORD MOTOR COMPANY	C3040-2
C341D-11	Courtesy of FORD MOTOR COMPANY	C3040-4

Measure:

Positive Lead	Measurement / Action	Negative Lead
C341E-4	Courtesy of FORD MOTOR COMPANY	C3040-5
C341E-2	Courtesy of FORD MOTOR COMPANY	C3040-8
C341E-7	Courtesy of FORD MOTOR COMPANY	C3040-7

Are the resistances less than 3 ohms?

Yes

GO to S10

No	REPAIR the affected circuit. GO to S13

S10 CHECK THE PASSENGER SEAT CUSHION BLOWER MOTOR CIRCUITS FOR A SHORT TOGETHER

Disconnect: Passenger Backrest Blower Motor C3039.

Measure:

Positive Lead	Measurement / Action	Negative Lead
C3040-1	Courtesy of FORD MOTOR COMPANY	C3040-2
C3040-3	Courtesy of FORD MOTOR COMPANY	C3040-4
C3040-3	Courtesy of FORD MOTOR COMPANY	C3040-7
C3040-4	Courtesy of FORD MOTOR COMPANY	C3040-7
C3040-5	Courtesy of FORD MOTOR COMPANY	C3040-8

Are the resistances greater than 10, 000 ohms?

Yes

GO to S11

No	REPAIR the affected circuits. GO to S13

S11 DETERMINE CUSHION BLOWER MOTOR OR SCME (FRONT SEAT CLIMATE CONTROL MODULE) FAILURE
- Remove the cushion blower motor from the passenger seat. REFER to: Front Seat Cushion Blower Motor .
- Remove the cushion blower motor from the driver seat and install it on the passenger seat.
- Connect: Passenger Cushion Blower Motor C3040.
- Connect: DSM C341D and C341E.
- Start the engine and check operation of the passenger seat climate controlled seat system.
Does the seat operate with the cushion blower motor from the other seat installed?

Yes INSTALL a new seat cushion blower motor. REFER to: Front Seat Cushion Blower Motor . GO to S13

No GO to S12

S12 CHECK THE SCME (FRONT SEAT CLIMATE CONTROL MODULE) OPERATION

Ignition OFF.

Disconnect and inspect all of the DSM connectors.

Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins as necessary
- pushed-out pins - install new pins as necessary

Reconnect the DSM connectors. Make sure they seat and latch correctly.

NOTE: Do not reconnect Driver Side Airbag In-Line C3368 or Passenger Side Airbag In-Line C3206 at this time.

Reconnect all previously disconnected connectors.

Ignition ON.

Operate the system and determine if the concern is still present.

Is the concern still present?

Yes	CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new DSM. REFER to: Driver Front Seat Module (DSM) . GO to S13

No	The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. GO to S13

S13 CHECK FOR SRS (SUPPLEMENTAL RESTRAINT SYSTEM) DIAGNOSTIC TROUBLE CODES (DTCS)
- WARNING: WARNING: Turn the ignition OFF and wait one minute to deplete the backup power supply. Failure to follow this instruction may result in serious personal injury or death in the event of an accidental deployment.
  
  Ignition OFF.
- Connect: Driver Side Airbag In-line C3368.
- Connect: Passenger Side Airbag In-line C3206.
- Connect all previously disconnected connectors.
- Ignition ON.
- Using a diagnostic scan tool, clear the RCM Diagnostic Trouble Codes (DTCs).
- Cycle the ignition OFF then ON.
- Using a diagnostic scan tool, perform RCM self-test.
Are any RCM Diagnostic Trouble Codes (DTCs) retrieved during self-test?

Yes REFER to: SUPPLEMENTAL RESTRAINT SYSTEM (2 OF 3) (HYBRID/ENERGI) .

No Repair is complete. RETURN the vehicle to the customer.