Pinpoint Test E : A Single Power Window Is Inoperative - RH (Right-Hand) Front
- E1 CHECK THE RH WINDOW CONTROL SWITCH POWER CIRCUIT FOR AN OPEN
- Ignition OFF.
- Disconnect: RH Front Window Control Switch C604.
- Ignition ON.
- Measure:
Positive Lead Measurement / Action Negative Lead C604-2 Ground
Is the voltage greater than 11 volts?
Yes GO to E2 No REPAIR the circuit. - E2 CHECK THE MASTER WINDOW CONTROL SWITCH NORMALLY CLOSED GROUND CIRCUITS FOR AN OPEN
- Ignition OFF.
Are the resistances less than 3 ohms?
Yes GO to E4 No GO to E3 - E3 CHECK THE POWER WINDOW CONTROL CIRCUITS FOR AN OPEN
- Disconnect: Master Window Control Switch C504B (if equipped with power rear windows) or C566A (if not equipped with power rear windows).
- If equipped with power rear windows, measure:
Positive Lead Measurement / Action Negative Lead C504B-7 C604-6 C504B-8 C604-3
- If not equipped with power rear windows, measure:
Positive Lead Measurement / Action Negative Lead C566A-7 C604-6 C566A-8 C604-3
Are the resistances less than 3 ohms?
Yes INSTALL a new master window control switch. No REPAIR the circuit in question. - E4 CHECK THE POWER WINDOW UPWARD AND/OR DOWNWARD OPERATION
- Ignition ON.
- To check downward window operation, connect fused jumper wires:
Positive Lead Measurement / Action Negative Lead C604-2 C604-7 C604-6 C604-1
- To check upward window operation, connect fused jumper wires:
Positive Lead Measurement / Action Negative Lead C604-2 C604-1 C604-6 C604-7
Does the RH front window move up and/or down?
Yes REMOVE the jumper wires. If the RH front window did not operate from the RH front window control switch, INSTALL a new RH window control switch. If the RH front window did not operate from the master window control switch, INSTALL a new master window control switch. No REMOVE the jumper wires. GO to E5 - E5 CHECK THE POWER WINDOW CIRCUITS FOR AN OPEN
- Ignition OFF.
- Disconnect: RH Front Power Window Motor C623.
Are the resistances less than 3 ohms?
Yes MAKE SURE there are no mechanical binding conditions preventing the glass mechanism from operating correctly. If a mechanical binding issue is found, REPAIR as necessary. If no mechanical binding condition exists, INSTALL a new RH front window regulator motor. No REPAIR the circuit in question.