Main Control Cover - 1.5L Duratec (90kW/120PS) - I3: Installation
WARNING: This page is about a different car, the 2018 Ford EcoSport. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the transmission main control cover seal for damage and install new if necessary.
-
NOTE: Install the studbolts in the locations noted during removal.
Install the main control cover, the bolts and the stud bolts.
Torque
: 106 lb.in (12 Nm)
- Connect the transmission electrical connector and the wiring harness retainers.
- Install the cooling fan motor and shroud.
- Install the air cleaner assembly.
- Fill the transmission with transmission fluid. Refer to: Transmission Fluid Level Check .