Symptom Chart: Starting System
WARNING: This page is about a different car, the 2018 Ford EcoSport. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to: Diagnostic Methods .
Symptom Chart
| Condition | Possible Sources | Actions |
|---|---|---|
| The engine does not crank -- without Push-button Start | Refer to the Pinpoint Test | GO to Pinpoint Test A |
| The engine does not crank -- with Push-button Start | Refer to the Pinpoint Test | GO to Pinpoint Test B |
| The engine cranks slowly | Refer to the Pinpoint Test | PERFORM the starter system component test. Refer to Starter Motor - Positive Circuit Test in this service information. |
| The engine cranks but will not start | Fuses PCM Fuel pump Fuel pump relay Starter Wiring, terminals or connectors |
Refer to Engine Controls - Symptom Charts (Except Diesel & Hybrid) . |
| Unusual starter noise | Refer to the Pinpoint Test | GO to Pinpoint Test C |
| The starter spins but the engine does not crank | Starter motor | INSPECT the starter motor mounting and engagement. REPAIR as necessary. |
| Damaged flexplate | INSPECT the flexplate for damaged, missing or worn teeth. REPAIR as necessary. | |
| The starter does not disengage from the flexplate | Starter relay Wiring, terminals or connectors |
REMOVE the starter relay. If the engine stops cranking, INSTALL a new relay. If the engine continues to crank, REPAIR circuit CDC25 (BN/GN) for a short to voltage. |