Engine Mount RH: Installation

WARNING: This page is about a different variant/trim than selected.

Install the engine mount and bolts.
Torque: 52 lb.ft (70 Nm)

Courtesy of FORD MOTOR COMPANY
Lower the engine onto the engine mounts and remove the special tools Use Special Service Tool: 303-F072 Support Bar, Engine, 303-050 (T70P-6000) Lifting Bracket, Engine.

Courtesy of FORD MOTOR COMPANY
Connect the oil cooler hoses and install the bolts.
Torque: 22 lb.ft (30 Nm)

Courtesy of FORD MOTOR COMPANY
Position the underbody shield and install the bolts.

Courtesy of FORD MOTOR COMPANY
Position the underbody shield and install the bolts.

Courtesy of FORD MOTOR COMPANY
Install the RH engine mount nut.
Torque: 46 lb.ft (63 Nm)

Courtesy of FORD MOTOR COMPANY
Install the LH engine mount nut.
Torque: 46 lb.ft (63 Nm)

Courtesy of FORD MOTOR COMPANY
- Install the CMP sensor and the bolt.
  Torque: 89 lb.in (10 Nm)
- Connect the CMP sensor electrical connector and the wiring harness retainers.
Courtesy of FORD MOTOR COMPANY
Install the battery heat shield and fasteners.
Torque: 80 lb.in (9 Nm)

Courtesy of FORD MOTOR COMPANY
Install the cowl extension and the fasteners.
Torque: 26 lb.ft (35 Nm)

Courtesy of FORD MOTOR COMPANY
Install the following items:
1. Refer to: Battery Tray .
2. Refer to: Cowl Panel Grille .
3. Refer to: Air Cleaner Outlet Pipe .
1. Install the strut tower cross brace and nuts.
  Torque: 41 lb.ft (55 Nm)
2. Attach the wiring harness retainer.
Courtesy of FORD MOTOR COMPANY
Connect the battery ground and positive cables. Refer to: Battery Disconnect and Connect .
Inspect and adjust the engine oil level.
Material: Castrol® EDGE® Supercar 5W-50 (WSS-M2C931-C)